Sliding Closet Doors Fall Off Track

Then retighten the screw close the doors and check the fit.
Sliding closet doors fall off track. Top bracket loosen the set screw on the top bracket and slide the bracket slightly along the track to adjust the space between the top of the doors. Sliding closet doors fall off tracks. Work the door slowly into the opening in this manner. Inspect the rollers and tighten them with a.
Stand back five feet or so and examine the gaps on the top and bottom. Adjusting the position of the door photo 1. The track has two channels that guide rollers that are attached to the top of each door that allow the doors to slide. If one side of your door is loose then it s most likely that a wheel or wheel brace is faulty.
First check the alignment of your closet doors. Moving the door when the back side is sliding on the ground is a little difficult. First check the alignment of your closet doors. 2 grab the door from both sides and lift it off the track.
Floor keepers are typically fastened to sliding doors by two screws. Take a look and ensure the entire wheel is in one piece and properly seated in the track. Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track. Stand back five feet or so and examine the gaps on the top and bottom.
Try holding your foot against the bottom of the door and pull gently on the top of the door to lift the back side. Bypass doors have a metal track screwed inside the top of the doorframe. Take a look and ensure the entire wheel is in one piece and properly seated in the track. Whether your door is unhinged from the top or bottom angle it at 15 to 30 degrees away from the unhinged track and slowly pull it outwards from the closet.
Take one of the doors down by lifting it and angling the bottom toward you until the rollers clear the top track then pulling it toward you. Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track. If one side of your door is loose then it s most likely that a wheel or wheel brace is faulty.